Effect of Process Control Agents on the FeSiB Powder Amorphisation by Wet Mechanical Alloying

E-ISSN： 2234-991x|2015|13|37-41

ISSN： 2234-9898

Source： Advanced Engineering Forum, Vol.2015, Iss.13, 2015-08, pp. : 37-41

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effects of milling intensity on amorphisation of Al–Fe mixed powders by mechanical alloying

By Zou Y. Saji S. Kusabiraki K.

Materials Science and Technology, Vol. 18, Iss. 8, 2002-08 ,pp. : 897-900

Maney Publishing

Access to resources Recommend Favorite

Mechanical alloying process and mechanical properties of Cu–SiC_p composite

By Gan K. K. Gu M. Y.

Materials Science and Technology, Vol. 22, Iss. 8, 2006-08 ,pp. : 960-964

Maney Publishing

Access to resources Recommend Favorite

Synthesis of the Fe-6.5% wt. Si Alloy by Mechanical Alloying

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 109-113

Trans Tech Publications

Access to resources Recommend Favorite

Mechanical alloying of Fe-C alloys

By Nowosielski R. Pilarczyk W.

International Journal of Microstructure and Materials Properties, Vol. 2, Iss. 2, 2007-06 ,pp. : 202-213

Inderscience Publishers

Access to resources Recommend Favorite

Synthesis of Fe₇₅Si_20-xB₅M_x (M=Ti, Ta or Zr) Powders by Wet Mechanical Milling

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 54-58

Trans Tech Publications

Access to resources Recommend Favorite