Analysis of the Process of Turning of Low-Rigidity Shafts

E-ISSN： 1662-7482|2015|791|238-245

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.791, 2015-10, pp. : 238-245

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Dynamic System of Grinding of Low-Rigidity Shafts

Applied Mechanics and Materials, Vol. 2015, Iss. 791, 2015-10 ,pp. : 281-289

Trans Tech Publications

Access to resources Recommend Favorite

Analysis of the Effect of Process Parameters for Circularity and Cylindricity Errors in Turning Process

Applied Mechanics and Materials, Vol. 2016, Iss. 852, 2016-10 ,pp. : 255-259

Trans Tech Publications

Access to resources Recommend Favorite

Nonlinear Analysis of Temperature during Orthogonal Turning

Applied Mechanics and Materials, Vol. 2018, Iss. 880, 2018-05 ,pp. : 309-314

Trans Tech Publications

Access to resources Recommend Favorite

Prediction of Mechanics Behaviors and Analysis on Dynamic Characteristics for Fiber Reinforced Metal Matrix Composites (MMC) Shafts

Applied Mechanics and Materials, Vol. 2014, Iss. 716, 2015-02 ,pp. : 154-158

Trans Tech Publications

Access to resources Recommend Favorite

FUZZY CLUSTERING MODELLING FOR SURFACE FINISH PREDICTION IN FINE TURNING PROCESS

By Hayajneh Mohammed

Machining Science and Technology, Vol. 9, Iss. 3, 2005-01 ,pp. : 437-451

Taylor & Francis Ltd

Access to resources Recommend Favorite