Analysis of Surface Roughness in Drilling of Fly Ash Filled Carbon Fibre Reinforced Composites

E-ISSN： 1662-7482|2015|813|505-510

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.813, 2015-12, pp. : 505-510

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Experimental Investigation and Analysis of Machining Parameters in Drilling of Fly Ash Filled Carbon Fibre Reinforced Composites

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 322-331

Trans Tech Publications

Access to resources Recommend Favorite

Delamination Analysis in Drilling Carbon Fiber-Reinforced Composites

Applied Mechanics and Materials, Vol. 2014, Iss. 697, 2015-01 ,pp. : 62-66

Trans Tech Publications

Access to resources Recommend Favorite

Some Researches Regarding the Surface Quality when Drilling Carbon Fiber Reinforced Composites

Applied Mechanics and Materials, Vol. 2015, Iss. 808, 2015-12 ,pp. : 155-160

Trans Tech Publications

Access to resources Recommend Favorite

Delamination in Drilling of Natural Fibre Reinforced Polymer Composites Produced by Compression Moulding

Applied Mechanics and Materials, Vol. 2015, Iss. 766, 2015-07 ,pp. : 796-800

Trans Tech Publications

Access to resources Recommend Favorite

Mathematical Modeling of Surface Roughness during Drilling of Resin Hybrid GFRP Composites

Applied Mechanics and Materials, Vol. 2016, Iss. 854, 2017-02 ,pp. : 18-25

Trans Tech Publications

Access to resources Recommend Favorite