Tool Wear Analysis in Turning Using Different Inserts and Different Lubrication Systems

E-ISSN： 1662-7482|2015|813|404-409

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.813, 2015-12, pp. : 404-409

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Cutting Temperature and Tool Wear Assessment of Turning Process with Minimal Quantity Lubrication

Applied Mechanics and Materials, Vol. 2015, Iss. 761, 2015-06 ,pp. : 313-317

Trans Tech Publications

Access to resources Recommend Favorite

Tool Wear Analysis of Al 6061 Reinforced with 10 wt% Al₂O₃ Using High Hardened Inserts

Applied Mechanics and Materials, Vol. 2015, Iss. 787, 2015-09 ,pp. : 643-647

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Pressure and Nozzle Angle of Minimal Quantity Lubrication on Cutting Temperature and Tool Wear in Turning

Applied Mechanics and Materials, Vol. 2014, Iss. 695, 2015-01 ,pp. : 676-679

Trans Tech Publications

Access to resources Recommend Favorite

Optimization and Performance Analysis of Uncoated and Coated Carbide Inserts during Hard Turning AISI D2 Steel Using Hybrid GRA-PCA Technique

Applied Mechanics and Materials, Vol. 2016, Iss. 852, 2016-10 ,pp. : 151-159

Trans Tech Publications

Access to resources Recommend Favorite

TURNING STUDIES OF DEEP CRYOGENIC TREATED P-40 TUNGSTEN CARBIDE CUTTING TOOL INSERTS - TECHNICAL COMMUNICATION

By Reddy T. V. Sreerama

Machining Science and Technology, Vol. 13, Iss. 2, 2009-04 ,pp. : 269-281

Taylor & Francis Ltd

Access to resources Recommend Favorite