Optimization and Prediction of Cutting Force and Surface Roughness in End Milling Process of AISI 304 Stainless Steel

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2015|813|362-367

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.813, 2015-12, pp. : 362-367

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Surface Roughness Prediction During Dry Turning of Austenitic Stainless Steel AISI 304

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 808, 2015-12 ,pp. : 54-59

Trans Tech Publications

Access to resources Recommend Favorite

Monitoring of Surface Roughness Based on Cutting Force and Cutting Temperature in Ball-End Milling Process by Utilizing Response Surface Analysis

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 799, 2015-11 ,pp. : 324-328

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Investigation to Improve Surface Integrity of Biomedical Devices by End-Milling AISI 316L Stainless Steel

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 789, 2015-10 ,pp. : 141-145

Trans Tech Publications

Access to resources Recommend Favorite

Improved Surface Integrity during End Milling AISI 316L Stainless Steel Using Heat Assisted Machining

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 752, 2015-05 ,pp. : 62-67

Trans Tech Publications

Access to resources Recommend Favorite

A Prediction Model of Surface Roughness in Micro End Milling

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 727, 2015-03 ,pp. : 354-357

Trans Tech Publications

Access to resources Recommend Favorite