Experimental Investigation and Parameter Optimization of Micro Holes Machining on Ti-6Al-4V Alloy

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2015|813|332-336

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.813, 2015-12, pp. : 332-336

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Finite Element Analysis and Experimental Investigation of Drilling of Titanium Alloy (Ti6Al4V)

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 342-346

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Investigation and Finite Element Analysis of Milling of Ti-6Al-4V Titanium Alloy by Studying Cutting Forces and Chip Microstructure

By  

Applied Mechanics and Materials, Vol. 2016, Iss. 852, 2016-10 ,pp. : 311-316

Trans Tech Publications

Access to resources Recommend Favorite

Fuzzy Modeling of Surface Roughness Parameters in Machining Ti-6Al-4V Alloy

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 766, 2015-07 ,pp. : 681-686

Trans Tech Publications

Access to resources Recommend Favorite

Effect of High Pressure Coolant on Tool Wear Phenomenon during Machining of Titanium Alloy Ti6Al4V

By  

Applied Mechanics and Materials, Vol. 2016, Iss. 826, 2016-03 ,pp. : 93-98

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Study on Milling Formation and Milling Force in Green Machining Ti6Al4V

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 727, 2015-03 ,pp. : 65-68

Trans Tech Publications

Access to resources Recommend Favorite