Consideration about the Determination and Control of the Key Characteristics as Part of Planning Quality of the Product Development Process

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2015|809|1269-1274

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.809, 2015-12, pp. : 1269-1274

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Expert System Software for Production Planning and Quality Control in Bleaching Dyeing and Finishing Process of Textiles Industry

By  

Applied Mechanics and Materials, Vol. 2016, Iss. 848, 2016-10 ,pp. : 259-262

Trans Tech Publications

Access to resources Recommend Favorite

Knowledge Gap and its Impact on Product and Process Quality

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 1176-1182

Trans Tech Publications

Access to resources Recommend Favorite

Highly Iterative Product Development Process for Engineering Projects

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 794, 2015-11 ,pp. : 532-539

Trans Tech Publications

Access to resources Recommend Favorite

A CPN Based Model for a Typical Product Development Process

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 740, 2015-04 ,pp. : 957-960

Trans Tech Publications

Access to resources Recommend Favorite

Uncertainty in Product Modelling within the Development Process

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 807, 2015-12 ,pp. : 89-98

Trans Tech Publications

Access to resources Recommend Favorite