The Influence of the Blank Holder Force during Forming Process of a U-Shaped Part Made from AZ31 Magnesium Alloy

E-ISSN： 1662-7482|2015|809|265-270

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.809, 2015-12, pp. : 265-270

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Investigation of the Rolling Direction Influence on Springback Effect of a U-Shaped Made from AZ31 Magnesium Alloy

Applied Mechanics and Materials, Vol. 2015, Iss. 809, 2015-12 ,pp. : 283-288

Trans Tech Publications

Access to resources Recommend Favorite

Determination of Material Parameters during Superplastic Forming of AZ31B Magnesium Alloy at Elevated Temperatures in Uniaxial Tensile Test

Applied Mechanics and Materials, Vol. 2015, Iss. 787, 2015-09 ,pp. : 437-441

Trans Tech Publications

Access to resources Recommend Favorite

Sliding Wear Map for AZ31 Magnesium Alloy

By Liang C. Han X. Su T. F. Li C. An J.

Tribology Transactions, Vol. 57, Iss. 6, 2014-11 ,pp. : 1077-1085

Taylor & Francis Ltd

Access to resources Recommend Favorite

Effects of Grain Refinement on the Prevention of Edge Cracking during Hot Rolling of AZ31 Magnesium Alloy

Applied Mechanics and Materials, Vol. 2015, Iss. 723, 2015-03 ,pp. : 914-918

Trans Tech Publications

Access to resources Recommend Favorite

Biodegradability of AZ31B Magnesium Alloy with a Permanganate Conversion Coating

Applied Mechanics and Materials, Vol. 2014, Iss. 707, 2015-02 ,pp. : 163-167

Trans Tech Publications

Access to resources Recommend Favorite