On Correlation of Pulses and Tool Elongations at Micro-Electrical Discharge Machining Aided by Ultrasonics

E-ISSN： 1662-7482|2015|809|309-314

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.809, 2015-12, pp. : 309-314

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Finite Element Modeling of an Ultrasonic Horn Integrating the Tool for Micro-Electrical Discharge Machining

Applied Mechanics and Materials, Vol. 2015, Iss. 809, 2015-12 ,pp. : 315-320

Trans Tech Publications

Access to resources Recommend Favorite

On Overlapping the Pulses on Cumulative Microjets Stage at Ultrasonically Aided Electrical Discharge Machining

Applied Mechanics and Materials, Vol. 2016, Iss. 834, 2016-05 ,pp. : 126-131

Trans Tech Publications

Access to resources Recommend Favorite

Micro hole machining by conventional penetration electrical discharge machine

By Kaminski P.C. Capuano M.N.

International Journal of Machine Tools and Manufacture, Vol. 43, Iss. 11, 2003-09 ,pp. : 1143-1149

Elsevier

Access to resources Recommend Favorite

State of the art electrical discharge machining (EDM)

By Ho K.H. Newman S.T.

International Journal of Machine Tools and Manufacture, Vol. 43, Iss. 13, 2003-10 ,pp. : 1287-1300

Elsevier

Access to resources Recommend Favorite

Surface Roughness at Wire Electrical Discharge Machining

Applied Mechanics and Materials, Vol. 2015, Iss. 760, 2015-06 ,pp. : 551-556

Trans Tech Publications

Access to resources Recommend Favorite