Effective Modeling of Phenomena in Over-Moisture Zone Existing in Porous Sand Mould Using the Simplified Simulation Systems Applied in Foundry

Publisher： Trans Tech Publications

E-ISSN： 1662-9507|2015|365|200-206

ISSN： 1012-0386

Source： Defect and Diffusion Forum, Vol.2015, Iss.365, 2015-08, pp. : 200-206

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Identification of the Moisture Distribution in the Intensively Heated Porous Sand Mould

By  

Defect and Diffusion Forum, Vol. 2016, Iss. 367, 2016-05 ,pp. : 121-129

Trans Tech Publications

Access to resources Recommend Favorite

BEM applied to damage phenomena in saturated porous media

By  

IOP Conference Series: Materials Science and Engineering, Vol. 10, Iss. 1, 2010-06 ,pp. : 425-434

IOP Publishing

Access to resources Recommend Favorite

Prediction of burn-on and mould penetration in steel casting using simulation

By Brooks B. E.   Beckermann C.   Richards V. L.  

International Journal of Cast Metals Research, Vol. 20, Iss. 4, 2007-08 ,pp. : 177-190

Maney Publishing

Access to resources Recommend Favorite

The use of SHS-process slag for the preparation of foundry sand

By  

IOP Conference Series: Materials Science and Engineering, Vol. 86, Iss. 1, 2015-06 ,pp. : 106-109

IOP Publishing

Access to resources Recommend Favorite

MOULD SLAG PROPERTY MEASUREMENTS TO CHARACTERIZE CC MOULD – SHELL GAP PHENOMENA

By MENG Y.   THOMAS B.G.   POLYCARPOU A.A.   PRASAD A.   HENEIN H.  

Canadian Metallurgical Quarterly, Vol. 45, Iss. 1, 2006-01 ,pp. : 79-94

Maney Publishing

Access to resources Recommend Favorite