The Influence of Different Fault Throws to the Height of Water-Flowing Fractured Zone

E-ISSN： 1662-8985|2014|1073|2088-2091

ISSN： 1022-6680

Source： Advanced Materials Research, Vol.2014, Iss.1073, 2015-01, pp. : 2088-2091

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Research on the Height of Water-Flowing Fractured Zone under the Weak Roof Strata and Fully Mechanized Caving Condition

Advanced Materials Research, Vol. 2015, Iss. 1092, 2015-04 ,pp. : 1448-1454

Trans Tech Publications

Access to resources Recommend Favorite

The Influence of Different Gas Welding Flame on Corrosion Behavior of the Carbon Steel’s Heat Affected Zone in Seawater

Advanced Materials Research, Vol. 2015, Iss. 1120, 2015-08 ,pp. : 1059-1063

Trans Tech Publications

Access to resources Recommend Favorite

A Study about Security of Wind Turbine Foundation in Different Width and Height Ratios

Advanced Materials Research, Vol. 2014, Iss. 1079, 2015-02 ,pp. : 566-573

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Spindle Speed on Exit Burr Height in Drilling Forging Brass

Advanced Materials Research, Vol. 2015, Iss. 1105, 2015-06 ,pp. : 159-163

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Research on Ultrasonic P-Wave Velocity Variation of Fractured Rock Mass under Different Stress Paths

Advanced Materials Research, Vol. 2014, Iss. 1065, 2015-01 ,pp. : 35-39

Trans Tech Publications

Access to resources Recommend Favorite