Experimental Study on Orbital Drilling Force and Machining Quality of CFRP

E-ISSN： 1662-8985|2014|1061|542-549

ISSN： 1022-6680

Source： Advanced Materials Research, Vol.2014, Iss.1061, 2015-01, pp. : 542-549

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of Machining Parameters on Temperature when Drilling Carbon Fiber Reinforced Polymer (CFRP) Using Coated Diamond Drills

Advanced Materials Research, Vol. 2015, Iss. 1115, 2015-08 ,pp. : 74-79

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Study on Delamination during Trimming of CFRP

Advanced Materials Research, Vol. 2015, Iss. 1089, 2015-03 ,pp. : 331-336

Trans Tech Publications

Access to resources Recommend Favorite

Machining Damage in Edge Trimming of CFRP

By Sheikh-Ahmad Jamal

Materials and Manufacturing Processes, Vol. 27, Iss. 7, 2012-07 ,pp. : 802-808

Taylor & Francis Ltd

Access to resources Recommend Favorite

An Experimental Study on Anchor Performance of Bare CFRP Tendons with Bond Type Anchor

Advanced Materials Research, Vol. 2014, Iss. 1082, 2015-02 ,pp. : 408-411

Trans Tech Publications

Access to resources Recommend Favorite

An Experimental Study on the Geometry of Microholes in Microelectric Discharge Machining

By Opoz Tahsin Tecelli

Materials and Manufacturing Processes, Vol. 24, Iss. 12, 2009-12 ,pp. : 1236-1241

Taylor & Francis Ltd

Access to resources Recommend Favorite