Simulation of the Surface Roughness by End Face Grinding Wheel with Ordered Abrasive Pattern

E-ISSN： 1662-8985|2015|1095|898-901

ISSN： 1022-6680

Source： Advanced Materials Research, Vol.2015, Iss.1095, 2015-04, pp. : 898-901

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Fabrication of the Electroplated CBN Wheel for Cylindrical Grinding with Abrasive Phyllotactic Pattern

Advanced Materials Research, Vol. 2014, Iss. 1077, 2015-02 ,pp. : 44-49

Trans Tech Publications

Access to resources Recommend Favorite

Experiment and Surface Roughness Prediction Model for Ti-6Al-4V in Abrasive Belt Grinding

Advanced Materials Research, Vol. 2015, Iss. 806, 2015-12 ,pp. : 42-47

Trans Tech Publications

Access to resources Recommend Favorite

Improvement of Surface Roughness with Micro-Axial Vibration of Spindle by Pressure Pulsation of Grinding Fluid Supplied through inside of Wheel

Advanced Materials Research, Vol. 2015, Iss. 806, 2015-12 ,pp. : 673-677

Trans Tech Publications

Access to resources Recommend Favorite

Grinding Wheel Abrasive Material Selection Using Fuzzy TOPSIS Method

By Maity Saikat Ranjan

Materials and Manufacturing Processes, Vol. 28, Iss. 4, 2013-04 ,pp. : 408-417

Taylor & Francis Ltd

Access to resources Recommend Favorite

Investigation on Surface Roughness in Abrasive Water-Jet Machining by the Response Surface Method

By Naresh Babu M. Muthukrishnan N.

Materials and Manufacturing Processes, Vol. 29, Iss. 11-12, 2014-12 ,pp. : 1422-1428

Taylor & Francis Ltd

Access to resources Recommend Favorite