Studies Regarding the Influence on the Surface Roughness Material of the Cutting Regime during the Milling Processing

E-ISSN： 1662-8985|2015|1128|271-281

ISSN： 1022-6680

Source： Advanced Materials Research, Vol.2015, Iss.1128, 2015-11, pp. : 271-281

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Influence of Metal Surface Roughness on Bonding Strength of Metal and Composite Material

Advanced Materials Research, Vol. 2015, Iss. 1095, 2015-04 ,pp. : 879-882

Trans Tech Publications

Access to resources Recommend Favorite

Investigation of Surface Roughness and Material Removal Rate for High Speed Micro End Milling on PMMA

Advanced Materials Research, Vol. 2015, Iss. 1115, 2015-08 ,pp. : 12-15

Trans Tech Publications

Access to resources Recommend Favorite

Influence of process parameters on the surface roughness in hotwire cutting of EPS foam sheet for VLM-S rapid prototyping process

By Ahn Dong-Gyu Lee Sang-Ho Yang Dong-Yol

Journal of Materials Science, Vol. 40, Iss. 21, 2005-11 ,pp. : 5699-5702

Springer Publishing Company

Access to resources Recommend Favorite

Effect of Cutting Speed during Turning of Low Carbon Steel on Mechanical Properties and Surface Roughness

Advanced Materials Research, Vol. 2015, Iss. 1096, 2015-05 ,pp. : 340-345

Trans Tech Publications

Access to resources Recommend Favorite

The influence of surface roughness in elliptical contacts

By Bjorklund S.

Tribology International, Vol. 34, Iss. 12, 2001-12 ,pp. : 841-845

Elsevier

Access to resources Recommend Favorite