Effect of Cutter Diameters on Surface Roughness Attained in High Speed End Milling of Soda Lime Glass

E-ISSN： 1662-8985|2015|1115|51-54

ISSN： 1022-6680

Source： Advanced Materials Research, Vol.2015, Iss.1115, 2015-08, pp. : 51-54

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Achievement of Ductile Regime Machining in High Speed End Milling of Soda Lime Glass by Using Tungsten Carbide Tool Insert

Advanced Materials Research, Vol. 2015, Iss. 1115, 2015-08 ,pp. : 39-42

Trans Tech Publications

Access to resources Recommend Favorite

Surface Roughness Prediction in High Speed End Milling Using Adaptive Neuro-Fuzzy Inference System

Advanced Materials Research, Vol. 2015, Iss. 1115, 2015-08 ,pp. : 122-125

Trans Tech Publications

Access to resources Recommend Favorite

Investigation of Surface Roughness and Material Removal Rate for High Speed Micro End Milling on PMMA

Advanced Materials Research, Vol. 2015, Iss. 1115, 2015-08 ,pp. : 12-15

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Analysis of Cutter Engagement during High Speed End Milling of H13

Advanced Materials Research, Vol. 2015, Iss. 1115, 2015-08 ,pp. : 70-73

Trans Tech Publications

Access to resources Recommend Favorite

Effect of crosshead speed on the fracture toughness of Soda-lime glass, Al2O3 and Si3N4 ceramics determined by the surface crack in flexure (SCF) method

By Park J-K. Yasuda K. Matsuo Y.

Journal of Materials Science, Vol. 36, Iss. 9, 2001-05 ,pp. : 2335-2342

Springer Publishing Company

Access to resources Recommend Favorite