Heat Transfer Analysis on Aluminum-Polymer Composite Molding Process

E-ISSN： 1662-9795|2015|667|187-193

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.667, 2016-02, pp. : 187-193

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Heat Transfer and Crystallization Modeling during Compression Molding of Thermoplastic Composite Parts

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 1507-1512

Trans Tech Publications

Access to resources Recommend Favorite

Modeling and flow analysis of pure nylon polymer for injection molding process

IOP Conference Series: Materials Science and Engineering, Vol. 114, Iss. 1, 2016-02 ,pp. : 400-406

IOP Publishing

Access to resources Recommend Favorite

Numerical Analysis of the Resin Transfer Molding Process via PAM-RTM Software

Defect and Diffusion Forum, Vol. 2015, Iss. 365, 2015-08 ,pp. : 88-93

Trans Tech Publications

Access to resources Recommend Favorite

A model of the interfacial heat-transfer coefficient for the aluminum gravity die-casting process

By Hallam C. Griffiths W.

Metallurgical and Materials Transactions B, Vol. 35, Iss. 4, 2004-08 ,pp. : 721-733

Springer Publishing Company

Access to resources Recommend Favorite

Сomputer-Aided Engineering of the Process of Injection Molding Articles Made of Composite Materials

Key Engineering Materials, Vol. 2017, Iss. 746, 2017-08 ,pp. : 269-274

Trans Tech Publications

Access to resources Recommend Favorite