Dynamic Model of Material Removal Process in Through-Feed Centerless Grinding Based on the Lagrange Equation

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2015|667|173-180

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.667, 2016-02, pp. : 173-180

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

An Investigation on the Workpiece Roundness Generation in Centerless Grinding Based on the Integration of Virtual Machine Tool and Workpiece Material Removal Mechanism

By  

Key Engineering Materials, Vol. 2015, Iss. 667, 2016-02 ,pp. : 588-594

Trans Tech Publications

Access to resources Recommend Favorite

Gantry Robot Dynamic Analysis Based on Lagrange’s Motion Equation

By  

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 1741-1746

Trans Tech Publications

Access to resources Recommend Favorite

The Adaptive Control of Accuracy at Centerless Grinding of Rolling Bearings

By  

IOP Conference Series: Materials Science and Engineering, Vol. 93, Iss. 1, 2015-10 ,pp. : 343-347

IOP Publishing

Access to resources Recommend Favorite

Modeling and Simulation of Single Abrasive-Grain Cutting Process in Creep Feed Grinding

By  

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 1241-1246

Trans Tech Publications

Access to resources Recommend Favorite

Research on Dynamic Behavior of Different Grinding Wheel Hub Material with FEM Method

By  

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 1216-1220

Trans Tech Publications

Access to resources Recommend Favorite