Validation of Kinematic Hardening Parameters from Different Stress States and Levels of Plastic Strain with the Use of the Cyclic Bending Test

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2015|639|385-392

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.639, 2015-04, pp. : 385-392

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Determination of the Anisotropic Hardening of Sheet Metals at Large Strain from Stretch Bending Test

By  

Key Engineering Materials, Vol. 2016, Iss. 725, 2017-02 ,pp. : 677-682

Trans Tech Publications

Access to resources Recommend Favorite

Cyclic Test of DP600 Steel under Tension-Compression Load for Different Pre-Strain Levels

By  

Key Engineering Materials, Vol. 2014, Iss. 635, 2015-02 ,pp. : 71-74

Trans Tech Publications

Access to resources Recommend Favorite

Validation of the Hardening Behaviors for Metallic Materials at High Strain Rate and Temperature by Using the Taylor Impact Test

By  

Key Engineering Materials, Vol. 2016, Iss. 715, 2016-11 ,pp. : 153-158

Trans Tech Publications

Access to resources Recommend Favorite

Simulation of Stress and Strain for Induction-Hardening Applications

By Ivanov Dmitry   Markegård Leif   Asperheim John   Kristoffersen Hans  

Journal of Materials Engineering and Performance, Vol. 22, Iss. 11, 2013-11 ,pp. : 3258-3268

Springer Publishing Company

Access to resources Recommend Favorite

Validation of Dynamic Hardening Models with Taylor Impact Tests at High Strain Rates

By  

Key Engineering Materials, Vol. 2014, Iss. 626, 2015-01 ,pp. : 389-396

Trans Tech Publications

Access to resources Recommend Favorite