A New Approach to the Evaluation of Forming Limits in Sheet Metal Forming

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2015|639|333-338

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.639, 2015-04, pp. : 333-338

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Sheet metal forming: A review

By Hosford William   Duncan John  

JOM, Vol. 51, Iss. 11, 1999-11 ,pp. : 39-44

Springer Publishing Company

Access to resources Recommend Favorite

On Practical Forming Limits in Superplastic Forming of Aluminum Sheet

By Luo Yingbing   Miller Craig   Luckey George   Friedman Peter   Peng Yinghong  

Journal of Materials Engineering and Performance, Vol. 16, Iss. 3, 2007-06 ,pp. : 274-283

Springer Publishing Company

Access to resources Recommend Favorite

A New Approach for Void Closure in Bulk Metal Forming

By  

Key Engineering Materials, Vol. 2016, Iss. 716, 2016-11 ,pp. : 595-604

Trans Tech Publications

Access to resources Recommend Favorite

A New Method for Testing Formability in Sheet Metal Forming at Biaxial Tensile State

By  

Key Engineering Materials, Vol. 2014, Iss. 626, 2015-01 ,pp. : 275-280

Trans Tech Publications

Access to resources Recommend Favorite

Thinning as a Failure Criterion During Sheet Metal Forming

By Sarkar B.   Jha B.K.   Mukerjee D.   Jha S.   Narasimhan K.  

Practical Failure Analysis, Vol. 2, Iss. 2, 2002-04 ,pp. : 63-64

Springer Publishing Company

Access to resources Recommend Favorite