Evaluation of Drawing Force and Thickness Distribution in the Deep-Drawing Process with Variable Blank-Holding

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2015|639|33-40

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.639, 2015-04, pp. : 33-40

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Estimating surface hardening profile of blank for obtaining high drawing ratio in deep drawing process using FE analysis

By  

IOP Conference Series: Materials Science and Engineering, Vol. 103, Iss. 1, 2015-12 ,pp. : 338-343

IOP Publishing

Access to resources Recommend Favorite

New Approach for Wrinkle Prediction in Deep Drawing Process

By  

Key Engineering Materials, Vol. 2015, Iss. 639, 2015-04 ,pp. : 459-466

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Sheet Thickness and Punch Roughness on Formability of Sheets in Hydromechanical Deep Drawing

By Anil Kumar A.   Satapathy Satyanarayan   Ravi Kumar D.  

Journal of Materials Engineering and Performance, Vol. 19, Iss. 8, 2010-11 ,pp. : 1150-1160

Springer Publishing Company

Access to resources Recommend Favorite

New Criterion for Prediction of the Wrinkle Formation in Deep Drawing Process

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 71-76

Trans Tech Publications

Access to resources Recommend Favorite

Study of Earing Defect during Deep Drawing Process with Finite Element Simulation

By  

Key Engineering Materials, Vol. 2015, Iss. 639, 2015-04 ,pp. : 91-98

Trans Tech Publications

Access to resources Recommend Favorite