Physically Based Criterion for Prediction of Instability under Stretch-Bending of Sheet Metal

E-ISSN： 1662-9795|2015|651|144-149

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.651, 2015-08, pp. : 144-149

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Fracture Prediction in Sheet Metal Stamping Based on a Modified Ductile Fracture Criterion

Key Engineering Materials, Vol. 2015, Iss. 639, 2015-04 ,pp. : 543-550

Trans Tech Publications

Access to resources Recommend Favorite

Fracture Prediction for Ultralow Carbon Steel Sheet Subjected to Draw-Bending Using Forming Limit Stress Criterion

Key Engineering Materials, Vol. 2015, Iss. 665, 2016-01 ,pp. : 1-4

Trans Tech Publications

Access to resources Recommend Favorite

Bending Limit Curves in Sheet Metal Bending Evaluation

Key Engineering Materials, Vol. 2017, Iss. 751, 2017-09 ,pp. : 180-185

Trans Tech Publications

Access to resources Recommend Favorite

Thinning as a Failure Criterion During Sheet Metal Forming

By Sarkar B. Jha B.K. Mukerjee D. Jha S. Narasimhan K.

Practical Failure Analysis, Vol. 2, Iss. 2, 2002-04 ,pp. : 63-64

Springer Publishing Company

Access to resources Recommend Favorite

Influence of the Sheet Metal Anisotropy on Polythickness of the Skin after Stretch Forming

Key Engineering Materials, Vol. 2017, Iss. 743, 2017-08 ,pp. : 207-211

Trans Tech Publications

Access to resources Recommend Favorite