Development and Characterization of Polymer Mixture (Binder) Based on Polyethylene Glycol (PEG) for a Superalloy A-286 to Powder Injection Moulding (MIM) Process

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2015|651|824-829

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.651, 2015-08, pp. : 824-829

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Development of PEG/PMMA Based Binders for Ti-Metal Injection Moulding

By  

Key Engineering Materials, Vol. 2016, Iss. 704, 2016-09 ,pp. : 130-138

Trans Tech Publications

Access to resources Recommend Favorite

Study of Processing Parameters for MIM Feedstock Based on Composite PEG-PMMA Binder

By Bakan H. I.   Jumadi Y.   Messer P. F.   Davies H. A.   Ellis B.  

Powder Metallurgy, Vol. 41, Iss. 4, 1998-01 ,pp. : 289-291

Maney Publishing

Access to resources Recommend Favorite

Injection Moulding of WC–6Co Powder Using Two New Binder Systems Based on Montanester Waxes and Water Soluble Gelling Polymers

By Youseffi M.   Menzies I. A.  

Powder Metallurgy, Vol. 40, Iss. 1, 1997-01 ,pp. : 62-65

Maney Publishing

Access to resources Recommend Favorite

Metal injection moulding of bronze using thermoplastic binder based on HDPE

By Herranz G.   Várez A.   Torralba J. M.   Levenfeld B.  

Powder Metallurgy, Vol. 50, Iss. 2, 2007-06 ,pp. : 184-188

Maney Publishing

Access to resources Recommend Favorite

The Development of Lead-Free Sliding Contacts Based on Bronze-Graphite Composites through Powder Injection Moulding

By  

Key Engineering Materials, Vol. 2017, Iss. 742, 2017-08 ,pp. : 205-212

Trans Tech Publications

Access to resources Recommend Favorite