Effect of Surface State of Die on Flow Rate of Steamed Bamboo Powder in Thermal Flow Test Using Capillary Rheometer

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2015|651|830-835

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.651, 2015-08, pp. : 830-835

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Critical state powder flow

By Stuart Dick David  

Powder Metallurgy, Vol. 48, Iss. 3, 2005-09 ,pp. : 209-211

Maney Publishing

Access to resources Recommend Favorite

Characterisation of powder bulk, dynamic flow and shear properties in relation to die filling

By Freeman R.   Fu Xiaowei  

Powder Metallurgy, Vol. 51, Iss. 3, 2008-09 ,pp. : 196-201

Maney Publishing

Access to resources Recommend Favorite

Influence of surface morphology, water flow rate, and sample thermal history on the boiling-water heat transfer during direct-chill casting of commercial aluminum alloys

By Wells M.   Li D.   Cockcroft S.  

Metallurgical and Materials Transactions B, Vol. 32, Iss. 5, 2001-10 ,pp. : 929-939

Springer Publishing Company

Access to resources Recommend Favorite

Effect of Flow Rate of Slurry in Micro-Channels on the Consistency of Polishing Rate

By  

Key Engineering Materials, Vol. 2015, Iss. 645, 2015-06 ,pp. : 462-468

Trans Tech Publications

Access to resources Recommend Favorite

The effect of density anisotropy on the yielding and flow behavior of partially consolidated powder compacts

By Dutton R.   Semiatin S.  

Metallurgical and Materials Transactions A, Vol. 29, Iss. 5, 1998-05 ,pp. : 1471-1475

Springer Publishing Company

Access to resources Recommend Favorite