The Surface Parameters Analysis of Magnesium Alloys Sheet during Warm Isothermal Forming

E-ISSN： 1662-9795|2015|642|217-221

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.642, 2015-05, pp. : 217-221

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Warm Hemming of Magnesium Sheet

By Carsley John Kim Sooho

Journal of Materials Engineering and Performance, Vol. 16, Iss. 3, 2007-06 ,pp. : 331-338

Springer Publishing Company

Access to resources Recommend Favorite

Spray Forming of Magnesium Alloys and Composites

By Ebert T. Moll F. Kainer K. U.

Powder Metallurgy, Vol. 40, Iss. 2, 1997-01 ,pp. : 126-130

Maney Publishing

Access to resources Recommend Favorite

Forming of Magnesium Alloys at 100 °C by Hydrostatic Extrusion

By Swiostek J. Göken J. Letzig D. Kainer K.U.

Journal of Materials Engineering and Performance, Vol. 15, Iss. 6, 2006-12 ,pp. : 705-711

Springer Publishing Company

Access to resources Recommend Favorite

Effect of Stress Relaxation on Springback of Steel Sheet in Warm Forming

Key Engineering Materials, Vol. 2016, Iss. 725, 2017-02 ,pp. : 671-676

Trans Tech Publications

Access to resources Recommend Favorite

Influence of welding parameters on stir zone microstructures during friction stir welding of magnesium alloys

By Borle S Izadi H Gerlich A P

Canadian Metallurgical Quarterly, Vol. 51, Iss. 3, 2012-07 ,pp. : 262-268

Maney Publishing

Access to resources Recommend Favorite