The Hammer Forging of Ti-6Al-4V Alloy

E-ISSN： 1662-9795|2015|641|198-201

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.641, 2015-05, pp. : 198-201

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Processing Maps of the Ti-6Al-4V Alloy in a Forging Process Design

Key Engineering Materials, Vol. 2015, Iss. 641, 2015-05 ,pp. : 190-197

Trans Tech Publications

Access to resources Recommend Favorite

Hot forging of Ti‐6Al‐4V alloy preforms produced by spark plasma sintering of powders

By Menapace C Vicente N Molinari A

Powder Metallurgy, Vol. 56, Iss. 2, 2013-04 ,pp. : 102-110

Maney Publishing

Access to resources Recommend Favorite

Comparative Analysis of Forging Rolling and Cross-Wedge Rolling of Forgings from Titanium Alloy Ti6Al4V

Key Engineering Materials, Vol. 2016, Iss. 687, 2016-05 ,pp. : 141-148

Trans Tech Publications

Access to resources Recommend Favorite

Cavitation and failure during hot forging of Ti-6Al-4V

By Semiatin S. Goetz R. Seetharaman V. Shell E. Ghosh A.

Metallurgical and Materials Transactions A, Vol. 30, Iss. 5, 1999-05 ,pp. : 1411-1424

Springer Publishing Company

Access to resources Recommend Favorite

Mechanochemical processing of nanocrystalline Ti-6Al-4V alloy

By Pirzada M. (Sam) Froes F. Patankar S.

Metallurgical and Materials Transactions A, Vol. 35, Iss. 6, 2004-06 ,pp. : 1899-1903

Springer Publishing Company

Access to resources Recommend Favorite