A Newly Developed Clamping Device for the Tension/Compression Test at Various Strain Rates

E-ISSN： 1662-9795|2014|626|353-358

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2014, Iss.626, 2015-01, pp. : 353-358

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Cyclic Test of DP600 Steel under Tension-Compression Load for Different Pre-Strain Levels

Key Engineering Materials, Vol. 2014, Iss. 635, 2015-02 ,pp. : 71-74

Trans Tech Publications

Access to resources Recommend Favorite

Comparison of 15Mo3 Strain Curves Obtained for Strain-Controlled Cyclic Bending and Tension-Compression Tests

Solid State Phenomena, Vol. 2016, Iss. 250, 2016-06 ,pp. : 85-93

Trans Tech Publications

Access to resources Recommend Favorite

Comparison of Three Methods for Material Hardening Parameter Identification under Cyclic Tension-Compression Loadings: Roll Levelling Case Study

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 957-962

Trans Tech Publications

Access to resources Recommend Favorite

Tension-Compression Tests for Springback Prediction of AHS Steel Using the Yoshida-Uemori Model

Key Engineering Materials, Vol. 2017, Iss. 728, 2017-03 ,pp. : 78-84

Trans Tech Publications

Access to resources Recommend Favorite

Research on Material Fatigue Test of Steel Fiber Reinforced Concrete under Tension and Compression Loading

Key Engineering Materials, Vol. 2017, Iss. 730, 2017-03 ,pp. : 353-357

Trans Tech Publications

Access to resources Recommend Favorite