Modification of Milling Tools and their Coating for Machining Sandwich Materials

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2015|818|284-287

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2015, Iss.818, 2015-06, pp. : 284-287

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Edge Cutting Tools for Machining of Hard-to-Cut Materials

By  

Materials Science Forum, Vol. 2016, Iss. 857, 2016-06 ,pp. : 213-220

Trans Tech Publications

Access to resources Recommend Favorite

Comparison of Milling Strategies when Machining Freeform Surfaces

By  

Materials Science Forum, Vol. 2016, Iss. 862, 2016-09 ,pp. : 18-25

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Multilayer Nanocomposite TiAlSiN/TiSiN/TiAlN Coating on Wear Behavior of Carbide Tools in the Milling of Hardened AISI D2 Steel

By  

Journal of Nano Research, Vol. 2016, Iss. 38, 2016-02 ,pp. : 9-17

Trans Tech Publications

Access to resources Recommend Favorite

Investigation of Centrifugal Impact Milling of Materials

By Levdanskii A. É.  

Journal of Engineering Physics and Thermophysics, Vol. 77, Iss. 5, 2004-09 ,pp. : 923-929

Springer Publishing Company

Access to resources Recommend Favorite

Cryogenic machining of hard-to-cut materials

By Wang Z.Y.   Rajurkar K.P.  

Wear, Vol. 239, Iss. 2, 2000-04 ,pp. : 168-175

Elsevier

Access to resources Recommend Favorite