Analysis of Short Glass Fiber Orientation in Injection Moulded Components

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2015|818|307-310

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2015, Iss.818, 2015-06, pp. : 307-310

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Temperature‐dependent coefficient of thermal expansion (CTE) of injection molded, short‐glass‐fiber‐reinforced polymers

By  

POLYMER ENGINEERING & SCIENCE, Vol. 32-3888, Iss. 11, 2015-11 ,pp. : 2661-2668

John Wiley & Sons Inc

Access to resources Recommend Favorite

Temperature‐dependent coefficient of thermal expansion (CTE) of injection molded, short‐glass‐fiber‐reinforced polymers

By  

POLYMER ENGINEERING & SCIENCE, Vol. 55, Iss. 11, 2015-11 ,pp. : 2661-2668

John Wiley & Sons Inc

Access to resources Recommend Favorite

Yield stress distribution in injection‐moulded glassy polymers

By  

POLYMER INTERNATIONAL, Vol. 959-8103, Iss. 11, 2015-11 ,pp. : 1527-1536

John Wiley & Sons Inc

Access to resources Recommend Favorite

Yield stress distribution in injection‐moulded glassy polymers

By  

POLYMER INTERNATIONAL, Vol. 64, Iss. 11, 2015-11 ,pp. : 1527-1536

John Wiley & Sons Inc

Access to resources Recommend Favorite

Comparison of different injection modes in edible oil minor components analysis

By  

JOURNAL OF SEPARATION SCIENCE (ELECTRONIC), Vol. 38, Iss. 13, 2015-07 ,pp. : 2278-2285

John Wiley & Sons Inc

Access to resources Recommend Favorite