Effect of Fe Content on Microstructures and Mechanical Properties of the Heat-Treated Squeeze Cast Al-5.0Cu-0.6Mn Alloy

E-ISSN： 1662-9752|2015|817|82-89

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2015, Iss.817, 2015-05, pp. : 82-89

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of Ultrasonic Vibration and Applied Pressure on the Microstructure and Mechanical Property of Al-5.0Cu-0.6Mn-0.6Fe Alloys

Materials Science Forum, Vol. 2016, Iss. 850, 2016-04 ,pp. : 559-565

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Mg and Cu Additions on Microstructure and Mechanical Properties of Squeeze Casting Al-Si-Cu-Mg Alloy

Materials Science Forum, Vol. 2016, Iss. 850, 2016-04 ,pp. : 511-518

Trans Tech Publications

Access to resources Recommend Favorite

Improvement of Microstructure and Mechanical Properties of Secondary AlSi8Cu2Mn Cast Alloy by Strontium

Materials Science Forum, Vol. 2017, Iss. 891, 2017-04 ,pp. : 350-353

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Heat Treatment on the Microstructure of Gravity Cast and Squeeze Cast Al-Si-Mg Alloy

Materials Science Forum, Vol. 2015, Iss. 830, 2015-10 ,pp. : 164-167

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Ageing Heat Treatment on Microstructure and Mechanical Properties of a Secondary Rheocast AlSi9Cu3(Fe) Alloy

Materials Science Forum, Vol. 2015, Iss. 828, 2015-09 ,pp. : 212-218

Trans Tech Publications

Access to resources Recommend Favorite