Simulation on the Effect of Bottle Wall Thickness Distribution using Blow Moulding Technique

Publisher： IOP Publishing

E-ISSN： 1757-899X|114|1|29-34

ISSN： 1757-899X

Source： IOP Conference Series: Materials Science and Engineering, Vol.114, Iss.1, 2016-02, pp. : 29-34

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Mould wall friction effects on micro injection moulding based on simulation of MIS

By  

IOP Conference Series: Materials Science and Engineering, Vol. 10, Iss. 1, 2010-06 ,pp. : 1368-1377

IOP Publishing

Access to resources Recommend Favorite

Injection Blow Moulding Single Stage Process – Approach of the Material Behaviour in Process Conditions and Numerical Simulation

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 805-811

Trans Tech Publications

Access to resources Recommend Favorite

Wall Thickness Distribution during a Combined Tube Spinning and Bending Process

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 1614-1619

Trans Tech Publications

Access to resources Recommend Favorite

Back extrusion and blow moulding of eutectoid Zn-Al alloy

By Jain K. K.   Duncan J. L.   Watson T. W.  

Canadian Metallurgical Quarterly, Vol. 13, Iss. 3, 1974-07 ,pp. : 511-516

Maney Publishing

Access to resources Recommend Favorite

Model and numerical simulation for the evolution of residual wall thickness in Water-Assisted Injection Molding

By  

IOP Conference Series: Materials Science and Engineering, Vol. 10, Iss. 1, 2010-06 ,pp. : 1358-1367

IOP Publishing

Access to resources Recommend Favorite