Tool Wear and Surface Roughness Evolution in Hole Making Process of Inconel 718

E-ISSN： 1662-9752|2016|862|11-17

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.862, 2016-09, pp. : 11-17

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Carbide tool wear mechanism in turning of Inconel 718 superalloy

By Liao Y.S. Shiue R.H.

Wear, Vol. 193, Iss. 1, 1996-04 ,pp. : 16-24

Elsevier

Access to resources Recommend Favorite

Wear Behavior of Multilayer Nanocomposite TiAlSiN/TiSiN/TiAlN Coated Carbide Cutting Tool during Face Milling of Inconel 718 Superalloy

Journal of Nano Research, Vol. 2017, Iss. 47, 2017-06 ,pp. : 11-16

Trans Tech Publications

Access to resources Recommend Favorite

Time Dependent Behavior Analysis of Inconel 718 in High Speed Grinding Process

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 56-63

Trans Tech Publications

Access to resources Recommend Favorite

The Effect of Cutting Speed and Feed Rate on Surface Roughness and Tool Wear when Machining Machining D2 Steel

Materials Science Forum, Vol. 2017, Iss. 909, 2017-12 ,pp. : 80-85

Trans Tech Publications

Access to resources Recommend Favorite

Influence of the relative positions of tool and workpiece on tool life, tool wear and surface finish in the face milling process

By Diniz A.E. Filho J.C.

Wear, Vol. 232, Iss. 1, 1999-09 ,pp. : 67-75

Elsevier

Access to resources Recommend Favorite