Surface Roughness and Cutting Force Components Evaluation in Hard Turning by Differently Shaped Cutting Tools

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2016|862|26-32

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.862, 2016-09, pp. : 26-32

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Force decomposition model for tool-wear in turning with grooved cutting tools

By Ee K.C.   Balaji A.K.   Li P.X.   Jawahir I.S.  

Wear, Vol. 249, Iss. 10, 2001-11 ,pp. : 985-994

Elsevier

Access to resources Recommend Favorite

Determination of Surface Roughness in Turning of Aluminum Bronze Alloy (UNS С 63020) Using Cutting Tools with Carbide Geometry Positive and Negative

By  

Materials Science Forum, Vol. 2014, Iss. 805, 2015-01 ,pp. : 368-373

Trans Tech Publications

Access to resources Recommend Favorite

Influence of cutting parameters on surface roughness in turning glass-fibre-reinforced plastics using statistical analysis

By Davim J Paulo   Mata Francisco  

Industrial Lubrication and Tribology, Vol. 56, Iss. 5, 2004-05 ,pp. : 270-274

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Edge Cutting Tools for Machining of Hard-to-Cut Materials

By  

Materials Science Forum, Vol. 2016, Iss. 857, 2016-06 ,pp. : 213-220

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Cutting Tool Edge Preparation on Cutting Force and Surface Integrity

By  

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 250-255

Trans Tech Publications

Access to resources Recommend Favorite