Optimal Cutting Conditions for Surface Finishing of Parts Made of Photopolymers

E-ISSN： 1662-9752|2016|862|192-199

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.862, 2016-09, pp. : 192-199

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Mechanical finishing honing: cutting regimes and surface texture

By Vrac Damir S. Sidjanin Leposava P. Balos Sebastian S.

Industrial Lubrication and Tribology, Vol. 63, Iss. 6, 2011-09 ,pp. : 427-432

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

New Technologies Development and Equipment for Local Shape-Forming of the Complicated Parts Made of Heat-Resistant Alloys under Superplastic Deformation Conditions

Materials Science Forum, Vol. 2016, Iss. 838, 2016-02 ,pp. : 615-620

Trans Tech Publications

Access to resources Recommend Favorite

The Influence of Finishing Strategy on the Quality of Surface

Materials Science Forum, Vol. 2018, Iss. 919, 2018-05 ,pp. : 18-24

Trans Tech Publications

Access to resources Recommend Favorite

Surface Hardening of Parts Arc

Materials Science Forum, Vol. 2016, Iss. 843, 2016-03 ,pp. : 225-230

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Study on Prestressed Cutting of Alloy Ring Parts

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 71-76

Trans Tech Publications

Access to resources Recommend Favorite