Study the Possibility of Controlling the Magnitude and Distribution of Residual Stress in the Surface Layer of the Product after the Process Double Duplex Burnishing

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2016|862|262-269

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.862, 2016-09, pp. : 262-269

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Analysis of the States of Deformation and Stress in the Surface Layer of the Product after the Burnishing Cold Rolling Operation

By  

Materials Science Forum, Vol. 2016, Iss. 862, 2016-09 ,pp. : 278-287

Trans Tech Publications

Access to resources Recommend Favorite

Study on Influential Factors of Grinding Surface Residual Stress in Dry for Controlling Workpiece Surface Integrity

By  

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 362-367

Trans Tech Publications

Access to resources Recommend Favorite

Wear Resistance Improvement by Nanostructured Surface Layer Produced by Burnishing

By  

Materials Science Forum, Vol. 2018, Iss. 917, 2018-05 ,pp. : 231-235

Trans Tech Publications

Access to resources Recommend Favorite

Aspects of Burnishing Rolling Process of the Surface Prepared in Different Previous Treatments

By  

Materials Science Forum, Vol. 2016, Iss. 862, 2016-09 ,pp. : 78-85

Trans Tech Publications

Access to resources Recommend Favorite

A Practical Method for Measuring Residual Stress Distribution by XRD after Needle or Hammer Peening: Application to a Simple Case

By  

Materials Science Forum, Vol. 2017, Iss. 905, 2017-09 ,pp. : 91-100

Trans Tech Publications

Access to resources Recommend Favorite