A Study on Working Process of Wire-EDM by Using Two Different Dielectric Fluids on HCHCr Alloy Steel

E-ISSN： 1662-7482|2016|852|212-217

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2016, Iss.852, 2016-10, pp. : 212-217

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Multi-Response Optimization of Wire-EDM Process Parameters of Titanium Alloy Using Taguchi Method and Grey Relational Analysis

Applied Mechanics and Materials, Vol. 2015, Iss. 772, 2015-08 ,pp. : 245-249

Trans Tech Publications

Access to resources Recommend Favorite

Optimization of Material Removal Rate in Wire-EDM Using Fuzzy Logic and Artifical Neural Network

Applied Mechanics and Materials, Vol. 2017, Iss. 867, 2017-08 ,pp. : 73-80

Trans Tech Publications

Access to resources Recommend Favorite

Comparative Study of Ti Alloy and Stainless Steel 304L Friction Welded Joint with Different Interlayer Process Methods

Applied Mechanics and Materials, Vol. 2015, Iss. 766, 2015-07 ,pp. : 739-744

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Powder Concentration in EDM Process with Powder-Mixed Dielectric (PMD-EDM)

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 304-308

Trans Tech Publications

Access to resources Recommend Favorite

An Investigation of Machining Time and Surface Roughness in Wire-EDM for Inconel 800

Applied Mechanics and Materials, Vol. 2015, Iss. 789, 2015-10 ,pp. : 20-24

Trans Tech Publications

Access to resources Recommend Favorite