Determination of Material Removal Rate and Radial Overcut in Electro Discharge Machining of AISI 304 Using Dimensional Analysis

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2016|852|160-165

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2016, Iss.852, 2016-10, pp. : 160-165

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Optimization of Tool Wear Rate during Electro Discharge Machining of NiTi Alloys Using Taguchi Method

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 787, 2015-09 ,pp. : 260-264

Trans Tech Publications

Access to resources Recommend Favorite

An Investigation of the Influences of EDM Parameters and Tool Geometries on Radial Overcut for Monel 400 Material with Tungsten Copper Electrode

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 766, 2015-07 ,pp. : 908-913

Trans Tech Publications

Access to resources Recommend Favorite

Electro Discharge Machining of WC/Ni Mixed Ceramic

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 309-316

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Analysis of Machining Parameters in WEDM of AISI D3 Steel Using Taguchi Method

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 799, 2015-11 ,pp. : 343-350

Trans Tech Publications

Access to resources Recommend Favorite

The Analysis for Chemico-Mechanical Practices Using in Polymer Material Machining

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 723, 2015-03 ,pp. : 892-895

Trans Tech Publications

Access to resources Recommend Favorite