Study on the Difference of Machinability between Iron-Based Sintered Materials and Steel Materials

E-ISSN： 1662-9752|2016|874|433-438

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.874, 2016-11, pp. : 433-438

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Sintered iron-based antifriction materials with added -SiC

By Chandrasekaran M. Singh P.

Wear, Vol. 206, Iss. 1, 1997-05 ,pp. : 1-7

Elsevier

Access to resources Recommend Favorite

The “Laser Machinability” of Polymeric Materials

Materials Science Forum, Vol. 2016, Iss. 862, 2016-09 ,pp. : 141-147

Trans Tech Publications

Access to resources Recommend Favorite

3D Investigation of Fatigue Crack Morphology and Crack Growth of Iron-Based Materials via Synchrotron X-Ray CT

Materials Science Forum, Vol. 2015, Iss. 833, 2015-12 ,pp. : 154-157

Trans Tech Publications

Access to resources Recommend Favorite

The machinability of sintered carbons based on the correlation between tool wear rate and physical and mechanical properties

By Masuda M. Kuroshima Y. Chujo Y.

Wear, Vol. 195, Iss. 1, 1996-07 ,pp. : 178-185

Elsevier

Access to resources Recommend Favorite

Study on High Speed Milling of Steam Turbine Blade Materials - Difference in Cutting Characteristics by Alloying Elements of Stainless Steel

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 439-444

Trans Tech Publications

Access to resources Recommend Favorite