The effects of concentration of cutting fluids on machining performance during end milling of steel St60

Author： Shokoohi Yousef   Khosrojerdi Ehsan   Shekarian Ehsan  

Publisher： Edp Sciences

E-ISSN： 2257-7750|17|4|407-407

ISSN： 2257-7777

Source： Mechanics & Industry, Vol.17, Iss.4, 2016-05, pp. : 407-407

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The investigation of the chip behaviour during the end milling cutting process

By  

MATEC Web of conference, Vol. 112, Iss. issue, 2017-07 ,pp. : 01014-01014

Edp Sciences

Access to resources Recommend Favorite

The high-performance machining of the curved surfaces with the progressive cutting geometry of the end mill

By  

MATEC Web of conference, Vol. 129, Iss. issue, 2017-11 ,pp. : 01057-01057

Edp Sciences

Access to resources Recommend Favorite

Influence of the cutting edge microgeometry on the tool life in austenitic stainless steel machining with carbide end mill

By  

MATEC Web of conference, Vol. 112, Iss. issue, 2017-07 ,pp. : 01016-01016

Edp Sciences

Access to resources Recommend Favorite

Effects of cutting parameters during turning 100C6 steel

By Serra R.  

EPJ Web of Conference, Vol. 6, Iss. issue, 2010-06 ,pp. : 13004-13004

Edp Sciences

Access to resources Recommend Favorite

Effect of machining parameters on surface finish of Inconel 718 in end milling

By  

MATEC Web of conference, Vol. 95, Iss. issue, 2017-02 ,pp. : 02009-02009

Edp Sciences

Access to resources Recommend Favorite