Effect of Gas Based Coolant Lubricants on Machinability of Titanium Alloy Ti6Al4V

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2016|705|233-239

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2016, Iss.705, 2016-09, pp. : 233-239

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Experimental Investigation of Effect of the Laser-Assisted Finish Turning of Ti-6Al-4V Alloy on Machinability Indicators

By  

Solid State Phenomena, Vol. 2017, Iss. 261, 2017-09 ,pp. : 135-142

Trans Tech Publications

Access to resources Recommend Favorite

Determination of FLD for Ti-6Al-4V Titanium Alloy Sheet

By  

Key Engineering Materials, Vol. 2016, Iss. 687, 2016-05 ,pp. : 171-178

Trans Tech Publications

Access to resources Recommend Favorite

Effect of high-temperature hydrogen treatment on the microstructure and properties of titanium alloy Ti-6Al-4V

By  

IOP Conference Series: Materials Science and Engineering, Vol. 22, Iss. 1, 2011-05 ,pp. : 67-77

IOP Publishing

Access to resources Recommend Favorite

Gas Nitriding and Oxidation of Ti-6Al-4V Alloy

By  

Defect and Diffusion Forum, Vol. 2018, Iss. 382, 2018-02 ,pp. : 155-159

Trans Tech Publications

Access to resources Recommend Favorite

Machinability of the EBM Ti6Al4V in Cryogenic Turning

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 1183-1188

Trans Tech Publications

Access to resources Recommend Favorite