Publisher： Trans Tech Publications
E-ISSN： 1662-9795|2016|716|443-450
ISSN： 1013-9826
Source： Key Engineering Materials, Vol.2016, Iss.716, 2016-11, pp. : 443-450
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
Related content
Influence of Edge Preparation Parameters on the Cutting Edge in Drag Finishing
Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. :
Access to resources
Recommend
The influence of hydrogen on the stress-corrosion cracking of low-strength Al-Mg alloys
By Jones R.
JOM, Vol. 55, Iss. 2, 2003-02 ,pp. :
Influence of the Cutting Fluid on Tool Edge Temperature in End Milling of Titanium Alloy
Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. :
Influence of Machining Characteristics on Ultra-Precision Cutting of Aluminum Alloys
Key Engineering Materials, Vol. 2014, Iss. 625, 2014-10 ,pp. :
Finishing Processes in Powder Metallurgy
By Beiss P.
Powder Metallurgy, Vol. 32, Iss. 4, 1989-01 ,pp. :