Deep Drawability and Bendability in Hot Stamping of Ultra-High Strength Steel Parts

E-ISSN： 1662-9795|2016|716|262-269

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2016, Iss.716, 2016-11, pp. : 262-269

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Numerical and Experimental Investigation into Hot Forming of Ultra High Strength Steel Sheet

By Liu Hongsheng Liu Wei Bao Jun Xing Zhongwen Song Baoyu Lei Chengxi

Journal of Materials Engineering and Performance, Vol. 20, Iss. 1, 2011-02 ,pp. : 1-10

Springer Publishing Company

Access to resources Recommend Favorite

Quenching–partitioning–tempering process for ultra-high strength steel

By Hsu (Xu Zuyao) T. Y.

International Heat Treatment & Surface Engineering, Vol. 2, Iss. 2, 2008-06 ,pp. : 64-67

Maney Publishing

Access to resources Recommend Favorite

The Effect of Punch Radius on the Deformation of Ultra-High Strength Steel in Bending

Key Engineering Materials, Vol. 2015, Iss. 639, 2015-04 ,pp. : 139-146

Trans Tech Publications

Access to resources Recommend Favorite

Production of high-strength hot-rolled steel to make energy-absorbing automotive parts

By Vasiliev I.

Metallurgist, Vol. 56, Iss. 1-2, 2012-05 ,pp. : 119-121

Springer Publishing Company

Access to resources Recommend Favorite

Evaluation of Bond Strength between Steel Fiber Reinforced Ultra-High Strength Concrete and Rebar

Key Engineering Materials, Vol. 2015, Iss. 665, 2016-01 ,pp. : 41-44

Trans Tech Publications

Access to resources Recommend Favorite