Parameters Design of Discontinuous Dot Indenter in Fine Blanking Process with Different Thickness Workpiece

E-ISSN： 1662-9795|2016|716|762-769

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2016, Iss.716, 2016-11, pp. : 762-769

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Numerical Study on the Comparison of Deformation Characteristics during the Fine Blanking Process of Spur Gears and Helical Gear

Key Engineering Materials, Vol. 2015, Iss. 639, 2015-04 ,pp. : 559-566

Trans Tech Publications

Access to resources Recommend Favorite

An Effect of Coating Parameters to Dry Film Thickness in Spray Coating Process

Key Engineering Materials, Vol. 2016, Iss. 709, 2016-10 ,pp. : 95-98

Trans Tech Publications

Access to resources Recommend Favorite

Modeling Blanking Process Using Multiple Regression Analysis and Artificial Neural Networks

By Al-Momani Emad

Journal of Materials Engineering and Performance, Vol. 21, Iss. 8, 2012-08 ,pp. : 1611-1619

Springer Publishing Company

Access to resources Recommend Favorite

Failure Analysis of a Sheet Metal Blanking Process Based on Damage Coupling Model

By Wen Y. Chen Z. Zang Y.

Journal of Materials Engineering and Performance, Vol. 22, Iss. 11, 2013-11 ,pp. : 3288-3295

Springer Publishing Company

Access to resources Recommend Favorite

Wear Mechanism and Ability for Recovery of Tool Steel on Blanking Die Process

Key Engineering Materials, Vol. 2016, Iss. 725, 2017-02 ,pp. : 572-577

Trans Tech Publications

Access to resources Recommend Favorite