Investigation on Wrinkling Deformation in Multi-Pass Incremental Sheet Forming Process

E-ISSN： 1662-9795|2016|725|578-585

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2016, Iss.725, 2017-02, pp. : 578-585

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Challenges and Process Strategies Concerning Multi-Pass Double Sided Incremental Forming

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 1122-1127

Trans Tech Publications

Access to resources Recommend Favorite

Observations on the Influence of Tool-Sheet Contact Conditions on an Incremental Forming Process

By Durante M.

Journal of Materials Engineering and Performance, Vol. 20, Iss. 6, 2011-08 ,pp. : 941-946

Springer Publishing Company

Access to resources Recommend Favorite

An Analytical and Numerical Investigation on Flange Wrinkling Behavior in Warm Forming Process of AA5754 Using Macro-Textured Tool Design

Key Engineering Materials, Vol. 2016, Iss. 716, 2016-11 ,pp. : 586-594

Trans Tech Publications

Access to resources Recommend Favorite

Investigation of Deformation Induced Martensitic Transformation during Incremental Forming of 304 Stainless Steel Wires

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 645-650

Trans Tech Publications

Access to resources Recommend Favorite

A Research of the Precision of Titanium Sheet Formed by Hot Incremental Sheet Forming Method

Key Engineering Materials, Vol. 2017, Iss. 749, 2017-09 ,pp. : 154-160

Trans Tech Publications

Access to resources Recommend Favorite