Development and identification of rheological model adapted for Powder Injection Moulding

E-ISSN： 2261-236x|80|issue|16006-16006

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.80, Iss.issue, 2016-10, pp. : 16006-16006

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

A biaxial test for rheological and formability identification

By Zidane I.

EPJ Web of Conference, Vol. 6, Iss. issue, 2010-06 ,pp. : 16004-16004

Edp Sciences

Access to resources Recommend Favorite

Process identification and model development of contaminant transport in MSWI bottom ash

By Dijkstra J.J. van der Sloot H.A. Comans R.N.J.

Waste Management, Vol. 22, Iss. 5, 2002-08 ,pp. : 531-541

Elsevier

Access to resources Recommend Favorite

Pneumatic powder injection technique as a tool for waste utilisation

By Jezierski Jan Janerka Krzysztof

International Journal of Environment and Waste Management, Vol. 2, Iss. 6, 2008-12 ,pp. : 636-646

Inderscience Publishers

Access to resources Recommend Favorite

Influence of metal inserts with microformed edges on subsequent injection assembly moulding for media tight electronic systems

MATEC Web of conference, Vol. 21, Iss. issue, 2015-08 ,pp. : 09013-09013

Edp Sciences

Access to resources Recommend Favorite

Identification and measurement of pastes rheological properties - effects of water dissociation

By Poitou A. Racineux G. Burlion N.

Water Science and Technology, Vol. 36, Iss. 11, 1997-01 ,pp. : 19-26

Elsevier

Access to resources Recommend Favorite