Effect of Duty Ratio at Different Pulse Frequency during Hole Drilling in Ceramics Using Electrochemical Discharge Machining

Publisher： Edp Sciences

E-ISSN： 2261-236x|77|issue|10004-10004

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.77, Iss.issue, 2016-10, pp. : 10004-10004

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Optimization of Machining Parameters for Minimization of Roundness Error in Deep Hole Drilling using Minimum Quantity Lubricant

By  

MATEC Web of conference, Vol. 78, Iss. issue, 2016-10 ,pp. : 01024-01024

Edp Sciences

Access to resources Recommend Favorite

Performance of nanocomposite ceramics by wire electrical discharge machining

By  

MATEC Web of conference, Vol. 34, Iss. issue, 2015-12 ,pp. : 01006-01006

Edp Sciences

Access to resources Recommend Favorite

An experimental result of surface roughness machining performance in deep hole drilling

By  

MATEC Web of conference, Vol. 78, Iss. issue, 2016-10 ,pp. : 01036-01036

Edp Sciences

Access to resources Recommend Favorite

Aspects of the determination of residual stresses in ceramics by ultrasounds hole-drilling

By Goanţă V.  

EPJ Web of Conference, Vol. 6, Iss. issue, 2010-06 ,pp. : 44003-44003

Edp Sciences

Access to resources Recommend Favorite

Drilling of Copper Using a Dual-Pulse Femtosecond Laser

By Cheng Chung-Wei   Chen Jinn-Kuen  

Technologies, Vol. 4, Iss. 1, 2016-02 ,pp. : 7-7

MDPI

Access to resources Recommend Favorite