The effect of cutting speed on residual stresses when orthogonal cutting TC4

Author： Liu Chaofeng  

Publisher： Edp Sciences

E-ISSN： 2100-014x|94|issue|01035-01035

ISSN： 2100-014x

Source： EPJ Web of Conference, Vol.94, Iss.issue, 2015-09, pp. : 01035-01035

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of value of the criterion of blunting on the selection of the brand of hard alloy and optimum cutting speed when turning austenitic steel

By  

MATEC Web of conference, Vol. 129, Iss. issue, 2017-11 ,pp. : 01021-01021

Edp Sciences

Access to resources Recommend Favorite

Investigation of formation mechanisms of chips in orthogonal cutting process

By Ma W.  

EPJ Web of Conference, Vol. 26, Iss. issue, 2012-08 ,pp. : 04008-04008

Edp Sciences

Access to resources Recommend Favorite

Noise Reduction Processes in Cutting with High-Speed Tools

By Toenshoff H. K.   Scherger A.   Westphal R.  

Noise Control Engineering, Vol. 17, Iss. 3, 1981-11 ,pp. : 126-131

Institute of Noise Control Engineering

Access to resources Recommend Favorite

An algorithm for controlling of cutting speed based on soft calculations

By  

MATEC Web of conference, Vol. 129, Iss. issue, 2017-11 ,pp. : 01064-01064

Edp Sciences

Access to resources Recommend Favorite

Technics Research on Polycrystalline Cubic Boron Nitride Cutting Tools Dry Turning Ti-6AL-4V Alloy Based on Orthogonal Experimental Design

By Jia Yunhai  

MATEC Web of conference, Vol. 142, Iss. issue, 2018-01 ,pp. : 03002-03002

Edp Sciences

Access to resources Recommend Favorite