Limits to radiative acceleration calculations: lithium and iron

E-ISSN： 1638-1963|17|issue|53-59

ISSN： 1633-4760

Source： EAS Publications Series, Vol.17, Iss.issue, 2006-01, pp. : 53-59

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

The accuracy with which it is possible to calculate theoretically the positions of energy levels and the low density (in frequency) of the grid on which opacity sampling is calculated bothlimit the accuracy with which the effect ofblends can be determined. For species such as Fe for which a large number of transitionsare involved in calculations, this leads to a small effect since, statistically, cancellations occur. However the effect can be large for an element such as Li with only a few transitions contributing to its radiative acceleration, g_rad(Li), at any given stellar radius. In particular, the Fe lines are shown to modify g_rad(Li) in and below the Fe convection zone but the modification depends on Fe level positions.This is analyzed quantitatively here using the OPAL data base. The g_rad(Li) are found to be uncertain by a factor of 2 in Pop I stars but of 1.03 in Pop II stars.