Publisher： Edp Sciences
E-ISSN： 2261-236x|40|issue|07015-07015
ISSN： 2261-236x
Source： MATEC Web of conference, Vol.40, Iss.issue, 2016-01, pp. : 07015-07015
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
Based on the demands of Confocal Auto-Focus system, the implementation method of signal measurement circuit and control circuit is given. Using the high performance instrumental amplifier AD620BN, low noise precision FET Op amplifier AD795JRZ and ultralow offset voltage Op amplifier OP07EP, a signal measurement circuit used to converse the two differential light intensity signal to electric signal is designed. And a control circuit which takes MCU MSP430F149 as core processes the former signal and generate a control signal driving the platform for auto-focusing. The experimental results proved the feasibility and correctness of circuits. And the system meets the design requirement.
Related content
Design and Implementation of A Circuit Board Calibration System
MATEC Web of conference, Vol. 40, Iss. issue, 2016-01 ,pp. :
Access to resources
Recommend
Access to resources
The Design of Angle Auto Direction-adjusting System for Wind Tunnel Motion Mechanism
MATEC Web of conference, Vol. 63, Iss. issue, 2016-07 ,pp. :
Pressure Pump Power Control in the Primary Circuit of the Heat Exchange System
MATEC Web of conference, Vol. 91, Iss. issue, 2016-12 ,pp. :
Master Control Design of Polar Detection Ice Radar
IOP Conference Series: Earth and Environmental Science, Vol. 17, Iss. 1, 2014-03 ,pp. :