A Tooth Flank Crowning Method by Applying a Novel Crossed Angle Function Between the Hob Cutter and Work Gear in the Gear Hobbing Process

Author： Wu Yu-Ren  

Publisher： Edp Sciences

E-ISSN： 2261-236x|52|issue|03001-03001

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.52, Iss.issue, 2016-04, pp. : 03001-03001

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Design and Analysis of Split Fixture for Gear Hobbing Machine

By  

MATEC Web of conference, Vol. 144, Iss. issue, 2018-01 ,pp. : 01014-01014

Edp Sciences

Access to resources Recommend Favorite

Simultaneous vibration and noise analysis as a method of tooth gear diagnostic

By Dabrowski Zbigniew   Osinsik Zbigniew  

INTER-NOISE and NOISE-CON Congress and Conference Proceedings, Vol. 1992, Iss. 3, 1992-07 ,pp. : 129-134

Institute of Noise Control Engineering

Access to resources Recommend Favorite

Analysis of justification for applying two gear sets within the universal gear reducers

By  

MATEC Web of conference, Vol. 121, Iss. issue, 2017-08 ,pp. : 01013-01013

Edp Sciences

Access to resources Recommend Favorite

influence of tooth profile error for an epicyclic gear noise

By Shoda Katsuhiko   Furukawa Toyoaki   Iwanaga Youichi   Matsunami Yuji  

INTER-NOISE and NOISE-CON Congress and Conference Proceedings, Vol. 1995, Iss. 4, 1995-07 ,pp. : 89-92

Institute of Noise Control Engineering

Access to resources Recommend Favorite

Selection of direct drives for tool and workpiece rotation for gear-hobbing machines of new generation

By  

MATEC Web of conference, Vol. 129, Iss. issue, 2017-11 ,pp. : 01006-01006

Edp Sciences

Access to resources Recommend Favorite