Sensitivity of Multi-Source SAR Backscatter to Changes in Forest Aboveground Biomass

Author： Huang Wenli Sun Guoqing Ni Wenjian Zhang Zhiyu Dubayah Ralph

Publisher： MDPI

E-ISSN： 2072-4292|7|8|9587-9609

ISSN： 2072-4292

Source： Remote Sensing, Vol.7, Iss.8, 2015-07, pp. : 9587-9609

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Accurate estimates of forest aboveground biomass (AGB) after anthropogenic disturbance could reduce uncertainties in the carbon budget of terrestrial ecosystems and provide critical information to policy makers. Yet, the loss of carbon due to forest disturbance and the gain from post-disturbance recovery have not been sufficiently assessed. In this study, a sensitivity analysis was first conducted to investigate: (1) the influence of incidence angle and soil moisture on Synthetic Aperture Radar (SAR) backscatter; (2) the feasibility of cross-image normalization between multi-temporal and multi-sensor SAR data; and (3) the possibility of applying normalized backscatter data to detect forest biomass changes. An empirical model was used to reduce incidence angle effects, followed by cross-image normalization procedure to lessen soil moisture effect. Changes in forest biomass at medium spatial resolution (100 m) were mapped using both spaceborne and airborne SAR data. Results indicate that (1) the effect of incidence angle on SAR backscatter could be reduced to less than 1 dB by the correction model for airborne SAR data; (2) over 50% of the changes in SAR backscatter due to soil moisture could be eliminated by the cross-image normalization procedure; and (3) forest biomass changes greater than 100 Mg·ha⁻¹ or above 50% of 150 Mg·ha⁻¹ are detectable using cross-normalized SAR data.